Replies to post #1459 on Cars, etc. (GEARHEAD)

[Phil(Hot Rod Chevy)]

Bob,

Here are the specs.

SPECIFICATIONS: Overall - 30'' deep, 48'' wide, 64-1/2'' high. Work area - 28'' deep, 46'' wide'', 28'' high, foot pedal operation, C-25 power gun, 1 steel and 2 ceramic nozzles, 28'' gauntlet-type gloves, automatic recycling system. Full-size 11 gauge steel side loading door, 22-20 gauge metal construction. Requires 10-15 cfm @ 80 psi (7 cfm with small nozzle/jet setup, extra cost). 125 psi max. 5 ft vac hose and Vac-35 vacuum system with powerful brush-type 115 volt motor pulls 70-80 cfm. Special Edition Red paint finish. Fully Assembled. Crate size: 56"w, 34"d, 70"h. Made in USA.

I have never tried to get an engine block in it, but I believe it would fit. It would be hard blasting it though because there wouldn't be a lot of room to work.

I usually just clean my blocks with soap and water and paint them anyway. There is usually so much oily crud on them that you don't have much rust to deal with.

I also have a small suction pot that I use on large items. I just hate wasting the sand, but sand is pretty cheap.

Later,
Phil