InvestorsHub Logo
Followers 14
Posts 574
Boards Moderated 0
Alias Born 12/05/2010

Re: techisbest post# 133105

Wednesday, 09/07/2011 11:25:32 AM

Wednesday, September 07, 2011 11:25:32 AM

Post# of 312015
Where did John ever say this would increase throughput?

Increased throughput is nothing more than pure hype and message board speculation. What John did say is it would allow less handling/shredding. He never mentioned any increased throughput at all ever.

Just keeping it real.

(6) "the Company also designed and has nearly completed manufacturing of a premelt system to allow waste plastic to enter the processor whole in bale form, or in large pieces (e.g. gas tanks, bumpers) without shredding or granulating the feedstock.
This premelt system will maximize production at third party facilities (i.e. paper mills or MRF sites) and other waste stream sites by allowing minimal handling of feedstock. Management’s highest priority is bringing modular processor #2 and 3 online so the Company can become cash flow positive"


"During the second quarter of 2011 the Company designed and engineered a premelt loader for the Plastic2Oil processor to eliminate handling, shredding, and bagging of waste plastic. With the premelt loader, bales or supersacks of plastic are set on a conveyor and then are loaded whole into the premelt reactor thereby eliminating shredding and much handling. During the modularization of the processor, the CEO was able to eliminate the off gas compression system in favor of a simplified low-cost off gas handling rack (4’ x 4’ x 4’) for better control and at 1/5 of the cost. The cost savings through modularization has been used to offset the cost of the premelt loader."