News 
Market Data 
Discover
Replies to post #41774 on QS Energy Inc (QSEP)
Laboratory and Scientific Testing
From 2010 through 2013, the Company worked with the U.S. Department of Energy (“US DOE”) to test its technology at the Department of Energy’s Rocky Mountain Oilfield Testing Center (“RMOTC”), near Casper, Wyoming. This third-party testing independently verified the efficacy of the Company’s technology operating in a controlled facility, using commercial-scale prototype of our AOT equipment. These tests were summarized in the US DOE Rocky Mountain Oilfield Test Center report dated April 4, 2012 (“ROMRC Report”), which reported AOT measured pressure loss reduction of 40% (RMOTC Report, Fig. 1, page 4) and viscosity reduction of 40% (RMOTC Report, Fig. 2, page 4); and reported observed reductions in line-loss and gains in pump operation efficiency across the entire length of the 4.4-mile test pipeline. A copy of the RMOTC April 4, 2012 Report is available on the Company website at: https://qsenergy.box.com/DOE-STWA-RMOTC-Report. A subsequent long-duration (24-hour) test at the RMOTC facility tested the effectiveness of AOT in treating oil overnight, as pipeline oil temperatures and viscosities drop. In its report dated May 3, 2012 to May 4, 2012, US DOE engineers recorded 56% reduction in viscosity of the AOT-treated oil versus untreated oil, with AOT effectively stabilizing oil viscosity throughout the overnight run despite dropping temperatures. A copy of the RMOTC May 3, 2012 to May 4, 2012 report is available on the Company website at: https://qsenergy.box.com/DOE-STWA-RMOTC-Overnight.
Laboratory testing of our AOT technology has been conducted by Dr. Rongjia Tao. Testing of the technology as applied to crude oil extraction and transmission has been conducted at Temple University in their Physics Department, in addition to the US DOE, at their Rocky Mountain Oilfield Testing Center, located on the Naval Petroleum Reserve #3 Teapot Dome Oilfield, north of Casper, Wyoming. In addition, a group led by Dr. Rongjia Tao, Chairman, Department of Physics of Temple University conducted experiments, using the laboratory-scale Applied Oil Technology apparatus at the National Institute of Standards and Technology (NIST) Center for Neutron Research (CNR). NIST is an agency of the U.S. Department of Commerce, founded in 1901 in Gaithersburg, Maryland.
Independent laboratory testing was also conducted as a collaborative effort by Temple University and PetroChina Pipeline R&D Center (“PetroChina”) in 2012. In its report dated June 26, 2012 (“PetroChina Report”), PetroChina concluded, “The above series of tests show that it is very effective to use AOT to reduce the viscosity of crude oil. We can see that AOT has significantly reduced the viscosity of Daqing crude oil, Changqing crude oil, and Venezuela crude oil, and greatly improved its flow rate.” (PetroChina Report, page 15). A copy of the PetroChina Report is available online at: https://qsenergy.box.com/PetroChina-STWA-Report
As previously reported in 2014, QS Energy installed and tested its commercial AOT equipment, leased and operated by TransCanada on TransCanada’s high-volume Keystone pipeline operation. The first full test of the AOT equipment on the Keystone pipeline was performed in July 2014, with preliminary data analyzed and reported by Dr. Rongjia Tao of Temple University. Upon review of the July 2014 test results and preliminary report by Dr. Tao, QS Energy and TransCanada mutually agreed that this initial test was flawed due to, among other factors, the short term nature of the test, the inability to isolate certain independent pipeline operating factors such as fluctuations in upstream pump station pressures, and limitations of the AOT device to produce a sufficient electric field to optimize viscosity reduction. Although Dr. Tao’s preliminary report indicated promising results, QS Energy and TransCanada mutually agreed that no conclusions could be reliably reached from the July 2014 test or from Dr. Tao’s preliminary report. As a result of this test, the Company modified its testing protocols and contracted with an independent laboratory, ATS RheoSystems, a division of CANNON (“ATS”), to perform follow-up tests at the TransCanada facility. This independent laboratory performed viscosity measurements at the TransCanada facility during subsequent testing in September 2014. As detailed in its field test report dated October 6, 2014, ATS measured AOT viscosity reductions of 8% to 23% depending on flow rates and crude oil types in transit. Over the duration of a 24-hour test intended to measure the recovery of the AOT treated oil from its reduced-viscosity treated state to its original pre-treated viscosity, ATS measured viscosity reductions of 23% three hours after treatment and 11% thirteen hours after treatment, with the crude oil returning to its untreated state approximately twenty-two hours after treatment. In its summary report dated February 5, 2015, ATS concluded that i) data indicated a decrease in viscosity of crude oil flowing through the TransCanada pipeline due to AOT treatment of the crude oil; and ii) the power supply installed on our equipment would need to be increased to maximize reduction in viscosity and take full advantage of the AOT technology. A copy of the ATS summary report dated February 5, 2015 is available on the Company website at: https://qsenergy.box.com/ATS-AOT-SummaryRpt. A copy of the ATS field test report dated October 6, 2014, with certain confidential information redacted, is available on the Company website at: https://qsenergy.box.com/ATS-AOT-Detailed-Report.
Although, as reported by ATS, the efficacy of the AOT technology operated in the TransCanada field test was constrained due to limitations of the electric field applied by that unit’s power supply, subsequent analysis by QS Energy personnel of ATS test results compared against laboratory tests performed at Temple University on oil samples provided by TransCanada revealed a single test run in which the electric field generated by the AOT was sufficient to fully treat the oil given operating conditions at the time of the test. In this test run, ATS measured a 23% reduction in viscosity three hours after AOT treatment. Laboratory tests at Temple University performed on a sample of crude oil provided by TransCanada of the same type treated in that specific field test measured a 27% reduction in viscosity in the laboratory immediately following treatment. Allowing for the actual three-hour of recovery time of the field test measurement, the resulting field test viscosity reduction of 23% correlates very well to the 27% viscosity reduction achieved in the laboratory setting.
09/17/17 8:19 AM
