Seafarer Exploration Corp (SFRX)

[blackduck]

Boatswain

I can appreciate your trying to figure this out

Here is a little information

30 foot lanes are to small for initial survey ( once a target of interest is found then you can run tighter lanes both NS and EW) the State of Florida requires 150 lanes which is to big you will miss targets

To do this right you have to pull two mags ( we have tested this to the point of overlap and know where the best set up is)

All anomalies are not targets, 1-4 anomalies can be the same target if you are doing this right.

3 square miles takes 6 days to survey max any way you cut it up, unless there is a lot of travel time

4-5 targets a day can be checked under the sand, while eliminating 4-20 anomalies again depending on travel time, weather etc.

GME use's SEA SPY mags and Bob software with a few other programs for different reasons

The last thing here is the Surveying, pin pointing and Dig and ID go hand in hand if you do not understand any of these three you are wasting your time. "Just saying"

www.gmexploration.com
Bobby